Building Your Own Laser – Part 6 – Wiring up Your Components

Building Your Own Laser – Part 6 – Wiring up Your Components

A PDF Wiring Guides for the DIY Laser is available here – Laser Plans & Guides | MW Laser

In this video I continue the Laser Build by wiring up the components, such as the Laser PSU, DC Power Supplies, Stepper Drivers and Stepper Motors, Ultimate Air Assist to the TROCEN AWC708S Controller.  The main electrical components I am using for this build are from Cloudray Laser Visit Cloudray’s AliExpress Store – 

DISCLAIMER: The producer of this video under no circumstances can be found liable for negligence by a viewer if they are seriously injured, dies or suffers damage to their property after acting upon or using the content contained in this video production.  Any person/s acting on information contained in this video do so at their own risk. The viewer also acknowledges they must follow all local and national laws and regulations when performing any work described in this video production. MAINS POWER CONNECTIONS MUST ONLY BE INSTALLED BY A LICENSED PROFESSIONAL.

The stepper motors I use are Leadshine 573S15-L and 573S09-L (Links Below For More Info)

The Ultimate Air Assist Kit –

Analog Ammeter (Available in 0-30mA and 0-50mA) Co2 Laser Parts | MW Laser

The Mechanical parts I used for this Laser Build are from Cloudray – This set below is for the size I am building 1300x900mm cutting area.  It comes with all mechanical components, laser lens head, mirror mounts, tube mounts stepper motor mounts, axis rails and timing belt.

Additional Phoenix Connectors can be found here on AliExpress.


Thanks for Visiting.

Until next time, take care

Cheers Matt

Back to blog