Part 4 – Continue Building Your Machine Enclosure

Building your own Co2 Laser can be challenging. In this video I continue the enclosure build and mount the X&Y Axis rails.

I also preview some of the components I will be installing in future videos for this build..
The mechanical parts I am using for this build are from Cloudray Laser.

The Aluminium T Slot I purchased from http://www.mkalu.com

The 1.6mm Aluminium Sheet I Purchased on ebay: (Sorry Link Removed – No Longer Valid)

Note: This will be continually added to throughout the build so check back Regularly for Updates.

Cloudray Mechanical Parts Set Inner Sliding Rails Kit – https://amzn.to/2XBYzK6

Cloudray Laser Power Supply – https://amzn.to/2LH9uzP

POWER SUPPLY ALSO AVAILABLE FROM MW LASER – Co2 Laser Parts | MW Laser

10600nm Laser Safety Goggles – https://amzn.to/2XCXpCE

Cloudray Lift Metal Parts with Stepper Motor and Motor Driver – https://s.click.aliexpress.com/e/_9wOm1l

CO2 Laser Tube Holders – https://amzn.to/2XynrXX

Cloudray CR35 + CR45 Laser Tube – https://amzn.to/2XzzF2k

RECI Laser Tubes – https://amzn.to/2xDPLbZ

Red Mushroom Emergency Stop Button – https://amzn.to/2xCwGa5

TROCEN AWC708S Controller – https://amzn.to/2xHkYuI NOTE: AWC708S has now Discontinued and
Replaced by Trocen AWC7813 – https://amzn.to/3jhJomK

The Aluminum Sheet Cutter I used was purchased off eBay (Sorry Link Removed – No Longer Valid)

3030 Cast Angle Brackets also off eBay (Sorry Link Removed – No Longer Valid)

As well as a bulk bag of Sliding t-Slot nuts for the 3030 profile (Sorry Link Removed – No Longer Valid)

Thanks for Visiting.
Until next time, take care
Cheers Matthew
Check Back Soon For More Information.

COMMENTING HAS BEEN TURNED OFF DUE TO CONSTANT SPAM MESSAGES ON THIS PAGE

Cart
Your cart is currently empty.